411 (Series 3-5) Exhaust Tailpipes

[David Olivant]

Necking couples! Have you ever been in a Hillman Imp?
David

[Hydroglen]

Seen one once....well it's the only reason I could think of, for a window
that can be used ONLY when parked!
Dorien

[Kevin H]

Here in Australia the earlier iconic Holden "panel van", loved by surfies and tradies, used to have a large window which hinged up from the roof at the back. I'm sure this was intended only for use when parked but it was common to see people driving around with it open on a hot day.

Of course being a van with only front seats it was much more practical for amorous activities as well. Surfies would often have a mattress in the back!

It looks like Holden might be planning to make them again http://www.holden.com.au/concept-cars/sandman-panel-van-

Back to John's problem. The cheapest and quickest solution to the exhaust stains has to be aftermarket exhaust tips that point downwards. But I suspect there's also a leak into the cabin from either the front or rear of the car.

[Nick Challacombe]

Kevin Howard wrote " The cheapest and quickest solution - has to be after
market
exhast tips that point downwards."

Just like the 407, the first use of a V8 in a Bristol.
Makes me think that the problem was always there and
an effective solution found. The 407 handbook advises
that the rear windows should be left open when driving
to facilitate the movement of air in the cockpit.

[John Keighley]

Many thanks to all who responded with these suggestions. On Monday I'll take the 410 to Cooma and the workshop with the only exhaust fabricating and pipe bending capability in town will blank off four metal tubes, weld these up, cut a hole in the bottom of each and then fit chrome caps over them to tidy up the job. As we have discovered, there are no exhaust tips of this type available Australia, so we will have to fabricate them. When all is complete I will post results and photos and let you know how we got on. Now armed with this information, I can throw some light for the workshop people on how the set-up should be. Many thanks for the photos, Kevin.
John Keighley

[UK6]

John,
It will be an exhaustive solution!

Brett

[Kevin H]

Originally Posted by John Keighley

.... On Monday I'll take the 410 to Cooma and the workshop with the only exhaust fabricating and pipe bending capability in town ....

Cooma ? - I bet they don't see many Bristols there :-)

[exgasman]

From memory the pipes on my 412 S1 pointed slightly up and had rectangular holes about four inches from the end on the underside and I'm quite sure they were not blanked off.
The mystery deepens!!