|
|
|
|||||||
| 8 & 10 cyl Bristol cars Type 407 onwards - restoration, repair, maintenance etc |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
|
20-02-23, 08:23 PM
|
|||
|
|||
Success!!!!!
I applied the propane torch for 30 minutes today. Then after some levering with a pickle fork, the spines came clear of the u-joint. Thanks for all the advice that got me to this point. Here's the suspension subframe/crossbeam out of the car!!!!! Once I have dismantled the steering and upper wishbones, it will go to the welder for repair of the rusted out areas. David Last edited by dwomby; 21-02-23 at 12:50 PM. 
|
|
21-02-23, 05:35 AM
|
|||
|
|||
|
Well done David!
That was quite a job! Must be very satisfying to get the subframe off. In some ways it's fortunate that you are restoring everything because it means get the angle grinder out if need be. Looking forward to seeing how you tackle the Wishbone Challenge :-) When you get the wishbones off, in the past I wrote a post about getting to bushes out. Probably don't need to tell you this, but make sure you clearly mark the wishbones arms so they can be re-assembled exactly where they were orignally. Kevin Last edited by Kevin H; 21-02-23 at 03:11 PM.
|
|
02-05-23, 10:21 AM
|
|||
|
|||
|
The subframe is back from the welder!!!!
The first pic shows the worst of the rusted area after the frame had been in an acid bath. The second shows the same area. The control arms are just being test-fitted. The plan is eventually to paint this black but I am leaving for Nova Scotia very soon and won't be back until September. So, for now, I will temporarily bolt the subframe back in 'as is' to ensure the main chassis rails don't spread apart under the weight of the engine during the summer. The engine has been supported while the subframe has been out. So it should bolt straight back in but we'll see how it goes!!!!! David Last edited by dwomby; 02-05-23 at 10:34 AM.
|
Hybrid Mode
