23-05-22, 03:26 PM
|
|
Member
|
|
Join Date: May 2018
Posts: 86
|
|
I am getting a little confused, which isn’t difficult!
My 410 has three track rods, one on the left hand side, one on the right hand side and one central.
The left and right hand side track rods need adjusting independently, which is quite difficult and time consuming if all 4 TRE’s have a left hand thread. Each side needs to be aligned. To carry out the adjustments one end of the track rod is removed from say the hub and turned inwards or outwards on the rod as needed. Once both side are set to the correct line the central track rod is then adjusted to achieve the correct toe in or toe out. The central rod does not adjust the tracking. How much easier it is with 2LH and 2RH on the track rods.
|
Threaded Mode