|
|
|
|||||||
| 6 cyl Bristol cars Type 400 to 406 - restoration, repair, maintenance etc |
|
|
Thread Tools | Search this Thread | Display Modes |
19-08-19, 04:17 PM
|
|||
|
|||
Brake master - desaster
Well, dear kolleges, I can add a new experience to this theme.
When my 400 gets hot, and also the brake fluid gets hot, I loose all my freeplay in the brake pedal to that point, that all four drums start to get hot and hotter, and finally start to fix and smell. When I now open the connecting nut of the brake line from the master cylinder fluid comes out und a lot of preassure. So, unfortunately, I have to remove the master and dismantle, cleane and fit a rep kit inside. And thats my question now, " Where to buy that brake master cylinder kit in best possibly quality?" I think that some if you may had a similar problem, and may therefore know to whom I have to go for a good rep kit, possibly with that little check valve. I thank you very much for your help and efforts. With very best regards to all Peter Last edited by STELLWAG P; 19-08-19 at 05:02 PM. 
|
Threaded Mode