Water leak from block on 403 engine

[Geoff Dowdle]

Mike,
a block stitcher can possibly only repairs cracks , not holes .
But it will be interesting to see what he recommends .
Maybe he can enlarge the hole to a point where there is metal say around 5mm thick , then tap a thread in the hole and make a screw in plug similar to the alloy plugs originally in the block.

After a repair is completed I recommend you use a sealer additive in the radiator fluid . In Australia there are a number of different types/brands available from Spare parts shops . They all should stop minor leaks but not holes. Follow the instructions on the packet.

Pls post the outcome of your completed fix.

Geoff

[zbigmak]

Originally Posted by Geoff Dowdle

Mike,
a block stitcher can possibly only repairs cracks , not holes .
But it will be interesting to see what he recommends .
Maybe he can enlarge the hole to a point where there is metal say around 5mm thick , then tap a thread in the hole and make a screw in plug similar to the alloy plugs originally in the block.

After a repair is completed I recommend you use a sealer additive in the radiator fluid . In Australia there are a number of different types/brands available from Spare parts shops . They all should stop minor leaks but not holes. Follow the instructions on the packet.

Pls post the outcome of your completed fix.

Geoff

Mike I am intrigued to know what was the outcome of your problem. Did the block repairer have a solution?
George

[mikebro]

Update - following up a recommendation from a BOC member, I contacted Nick Hood of Surelock in Oakham Rutland. He tells me he has repaired several Bristol 2 litre blocks over the years. He has seen my photos and is confident he can repair my block for me. It's now up to me to decide whether to send the block down to Nick (it won't be cheap!) or try the diy solution of a plate bolted on. I'm leaning towards getting it done properly, having spent so much time on the chassis and body already. I'm not quite ready to get the engine out yet. So bear with me and I'll post any further developments.

Mike

[mikebro]

My 100A engine is now with Nick Hood of Surelock. He is cutting out corroded metal all the way down the side of the block. He will be making a new piece and stitching it in.

[zbigmak]

Please let us know how you get on. I have a similar problem and need to find a solution so I would be more than happy to hear of your progress and how successful will be the end result.
George

[mikebro]

Stitching at Surelock completed and successfully pressure tested.. The water ways have also been flowed to remove loose corrosion products and ceramic sealed. It will be some time before I can run the engine for the real test, but it all looks good.

[mikebro]

Thought some of you would be interested to see some photos of the repair. As you can see, a large hole was cut out which removed all the corroded metal, some of which was part of a previous repair from way back. A new piece of cast iron was then stitched in, and then the whole water system ceramic coated internally, before finally pressure testing.