Bristol Cars - Owners and Enthusiasts Forum  

Go Back   Bristol Cars - Owners and Enthusiasts Forum > Bristol Forums > 6 cyl Bristol cars

6 cyl Bristol cars Type 400 to 406 - restoration, repair, maintenance etc

AP Fuel pump

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #13 (permalink)  
Old 08-04-14, 02:42 PM
Member
 
Join Date: Sep 2010
Posts: 263
Default

Thanks for your reply Geoff
The pump came with the car & I have no reason to doubt that it is not the correct one. It is stamped 4516xx. I did have a note of the lever but have mislaid it for the moment.
Once upon a time it worked OK!

I believe the (new) diaphragm is fitted correctly and I have put in new valves which give a good blow & weaker suck.
It is the correct diaphragm kit. Checked it against the new Standard pump. The primer works immediately and the lever lifts about half an inch before operating the diaphragm which is the same for the Standard pump.

I don't know if the pump is producing the correct pressure but petrol is sucked through when it is manually primed, it does pump when running (disconnected the outlet pipe) and I can blow petrol through the disconnected pipe from the tank.

The line has two clear full flow paper filters, one at the tank and the other below the pump because of fuel problems. Previously it worked OK with a clear filter at the front and a large VW filter at the rear.

The pump I have ordered gives 2.5 to 4.5 psi.

Regards, Peter
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


All times are GMT. The time now is 02:17 PM.


This is the live site

Search Engine Friendly URLs by vBSEO 3.6.0 PL2