View Single Post
  #8 (permalink)  
Old 16-08-20, 09:43 PM
LarryW LarryW is offline
Member
 
Join Date: Dec 2019
Posts: 39
Default Front section removed in one piece

I was able to remove the front section in a single piece. This was accomplished with only minimal unbending at the rear of the fenders (wings) and no unbending required for the body in front of the windshield. The latter was accomplished by cutting out the steel piece over which the piece of the body in front of the windshield is bend. Only two inch-long cuts on the steel piece are required to remove that steel section.
Attached Images
File Type: jpg Front removed.JPG (544.8 KB, 28 views)
File Type: jpg front removedb.JPG (515.6 KB, 26 views)
Reply With Quote