406 trim
 

I am rebuilding a 406

can someone send me some pics of

the door trim / seals top and bottom

the rear interior lights

and this may be a silly question

what's stopping me putting inertia seat belts for the from seats with the real mounted in the centre of the car by the tunnel and the connector on the outer side by the door

thanks Mike

Nothing as far as I can see. My 408 has its static front seat belts installed that way.

David

thanks

is there any chance you could send me a Pic

my email is mikej.woollard@icloud.com

cheers

Certainly. Give me a few minutes..........................

My mountings are a type I have not seen before.

David

door seals 406
 

still need help with pics or seal profiles for a 406
I'm almost ready to get it on the road as it' now insured and taxed so can someone help please


Mike

thank you for your help
I have now installed inertia belts front and back in the 406

so other than trying to find out what sort of seal is used on the doors I'm ready to drive

once again thanks

Mike

Mike, where did you put your rear seat belt reels?

David

I added some extra angle steel across the back of the car under the parcel shelf and then mounted the reels horizontally with the lap section bolted to the wheel arch and the catch bolted to the centre channel

hope that helps

do you have and pictures of the lower door seals/ furflex please

Don't know if mine on the bottom of door are original but here you are.

David