Bristol Cars - Owners and Enthusiasts Forum  

Go Back   Bristol Cars - Owners and Enthusiasts Forum > Search Forums

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: GrahamH
Forum: 6 cyl Bristol cars 23-06-22, 06:31 PM
Replies: 3
Views: 1,049
Posted By GrahamH
Strater Pinion

Thanks for the info. The part no 291069 was key, and luckily they appear availble. I should be sorted soon.
I have also been advised that a high torque starter motor type Wosp LMS037 would be a good...
Forum: 6 cyl Bristol cars 22-06-22, 09:19 AM
Replies: 3
Views: 1,049
Posted By GrahamH
Starter Motor

I need a 9 tooth pinion for a Lucas starter motor as fitted to 403 models, engine 100A.
The pinion part number is 25026B. Any ideas?
Forum: 6 cyl Bristol cars 16-12-18, 09:53 PM
Replies: 10
Views: 2,715
Posted By GrahamH
403 Sparking plugs and float level

Thanks again, both for advice and photograph.

Will take on board and get the float levels sorted, along with the fuel consumption and the plug fouling. May take me a little while but will report...
Forum: 6 cyl Bristol cars 15-12-18, 03:56 PM
Replies: 10
Views: 2,715
Posted By GrahamH
Thanks. Given the history of flooding and the...

Thanks. Given the history of flooding and the fact that petrol consumption is high at 15 - 18mpg I will certainly look at the float levels. Previously mixture has only been checked by gas analyser on...
Forum: 6 cyl Bristol cars 13-12-18, 09:08 PM
Replies: 10
Views: 2,715
Posted By GrahamH
403 Sparking Plugs

I am using the "hotter" plugs for touring.

Fuel mixture recently checked was correct although exhaust has been high in HC. Oil consumption is minimal.

The Solex carbs were re-built by Carburetter...
Forum: 6 cyl Bristol cars 29-11-18, 08:52 PM
Replies: 10
Views: 2,715
Posted By GrahamH
403 Sparking Plugs

I will seek out the plugs mentioned and look into the discharge ignition system.
Will give feed back upon further experimentation. Hopefully to report sucess!
Forum: 6 cyl Bristol cars 27-11-18, 11:26 AM
Replies: 10
Views: 2,715
Posted By GrahamH
403 Sparking plugs

The plugs on my 403 are prone to "coaking" up after a few months after service. Fuel mixture has been checked and ok. I always put the choke in as soon as possible and make sure the engine is warmed...
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT. The time now is 01:28 PM.


This is the live site

Search Engine Friendly URLs by vBSEO 3.6.0 PL2